Samson series 43, Translation Of Original Instructions

Page: 11 / 56

EB 2430 EN 1-7
Safety instructions and measures
1.3 Notes on possible property damage
NOTICE
!
Risk of control thermostat damage due to incorrectly attached slings.
Î
Do not attach load-bearing slings to the control thermostat.
Risk of leakage and control thermostat damage due to excessively high or low tight-
ening torques.
Observe the specified torques when tightening control thermostat components. Exces-
sive tightening torques lead to parts wearing out more quickly. Parts that are too loose
may cause leakage.
Î
Observe the specified tightening torques (see 'Tightening torques' in Annex).
Risk of control thermostat damage due to the use of unsuitable tools.
Certain tools are required to work on the control thermostat.
Î
Only use tools approved by SAMSON.
When in doubt, consult SAMSON.
Risk of the process medium being contaminated through the use of unsuitable lubri-
cants and/or contaminated tools and components.
Î
Keep the control thermostat components and the tools used free from solvents and
grease.
Î
Make sure that only suitable lubricants are used.
Incorrect control due to the formation of ice on the control thermostat.
Medium temperatures below 0 °C may cause ice to form on the control thermostat, de-
pending on the air humidity. This may affect, in particular, the functioning of the plug
or control thermostat stem guide.
Î
Prevent the formation of ice by taking appropriate precautions (e.g. enclosure,
trace heater etc.). The plant operator is responsible for selecting and implementing
appropriate precautions. See the 'Installation' section.