Operator's manual
Arm
Flail head
- 49 -
Fig. 59. Shut-off valve placed on tank
6.5.3.
Multiplier with pump set
Tightness of connections and oil level in multiplier (10) should be examined as well as
tightness of connection of hoses to pumps (51). This activity should be performed at least once a
week (Fig. 60).
Fig. 60. Mounted multiplier with pump set
Leaks in casing of multiplier should be removed by tightening casing bolts and sealing with
silicone. If oil level is low, take out air vent (53) and refill oil up to about 1L (half the inspection
window (52). Then air vent should be tightened anew.
Drippings at connecting hoses to pumps should be removed by tightening bolts, possibly
sealing should be replaced.
6.4.4. Suction filter CCA 302 CD1
Suction filter is equipped with two inserts CS 100 (54), contamination of which is determined
with use of indicator located in upper part of casing MPS 300 (55) (Fig. 61).
At commission these inserts (54) should be replaced after 100 h, next replacement after 500 h
of operation, if indicators do not show any contamination.
If indicators show contamination, these inserts should be replaced regardless of the operation
time. Contamination level should be controlled daily. No indicators control and no replacement of
inserts may lead to damaging hydraulics parts, what is not covered by warranty. During control of
indicators attention should be paid to condition of hoses and potential leaks. If such occur, seats and
clip bands should be tightened. Applied inserts and indicators must be purchased at manufacturer's or
at recommended stores. Use of non-genuine sub-assemblies may lead to damage, which is not
covered by warranty.
49
OFF
ON
50
51
53
52
