Operator's manual
Arm
Flail head
- 28 -
4.9.
OHP recommendations during operation - remarks for operator
If You wish to operate on full reach make sure, whether the tractor's static allows this.
Driver
–
Your safety depends of Your imagination and following the rules.
The SaMASZ company has not conducted any tests on static. Therefore the user should pay
special attention and be careful and potentially following his own efforts determine a slope
parameter which allows for proper set operation.
CAUTION:
Operation at slope greater than 8
o
may lead the set to fall and therefore put
health and life of the operator in danger.
CAUTION:
When the set comprising the tractor and the machine is tilted too much
immediately lower the machine onto the ground and stop the tractor. Further
drive is possible only after reducing the arm length or alteration of follow path.
CAUTION:
The above recommendations are general. The manufacturer does not bear any
responsibility for the operator's safety during operation.
CAUTION:
Any service and repair operations should be conducted with the tractor drive
disconnected, ignition key out and all rotating parts in the complete standstill.
4.10.
Safety decals and their meaning
CAUTION:
a)
all warning decals (labels) should be clean and legible,
b)
lost or damaged decals (labels) must be replaced,
c)
new decals (labels) may be ordered at the manufacturer.
N-01
N-02
N-3
N-4
Be extremely careful
when PTO shaft is
rotating
Caution: flail knives!
Do not get near
operating machine
Prior to the machine
operation read the
operator's manual
carefully
Prior to approaching
any maintenance or
repair works, the
machine shall be
disconnected
