Operator's manual
Arm
Flail head
- 31 -
5.
OPERATION
CAUTION:
During storing of the machines in company SaMASZ the cylinders are
protected by special grease in order to secure them against weather which may
cause their premature wear. Before starting the operation excess grease should
be removed from the cylinders.
5.1.
Attaching the arm to the tractor
Extension arm should be mounted on tractor with use of rear 3-point linkage, as provided on
Fig. 27. Upon complete mounting of arm adjust machine’s alignment on even ground with use of
upper link (40) so that the machine is set horizontally in relation to the ground. Tensioning strands
(41) must be tensioned and set on the same level. Their use ensures a stable position of the tractor-
machine set. The strands are not intended to protect the machine against falling. When using
extension arm, hydraulic actuator should be locked. Strands (41) should be attached to the tractor
depending on the design of hitches on the tractor.
CAUTION:
Do not adjust the tractor's lower strands (lifting/lowering) once the set is
stabilised using the tensioning strands. Otherwise both the machine and the
tractor could be damaged
!
Fig. 27. Machine lifted onto rear tractor's 3-point linkage
5.2.
Preparing machine for transport
Control panel should be installed in tractor’s cabin. Tractor operating on public road should be
equipped with yellow flashing light and warning triangle (Fig. 28).
CAUTION:
For transport set the arm KWT 651 with working head as farthest behind the
tractor as possible (Fig. 28).
40
41
