43
OPERATOR’S MANUAL
REAR EXTENSION ARMS
KWT, CAMEL, KOLIBER, KW, LAMA
Control panel and its functions:
Fig. 43.
Control panel
1.
Power switch. Once the feeding is switched off, all diodes one by one light up and go out, and diode
(
3
) starts to blink.
2.
Control switch off. To turn control off, hold button (
2
) for around 2 seconds. Turning control on is
signaled by a diode (
3
), which turns to steady light.
3.
Diode signals turning both power and control on.
4.
Safety breakaway device.
5.
Button for switching to mowing head's right-hand gears and diode signaling turning the head on.
To turn the head on, press and hold button (3) for around 2 seconds. In order to turn the head off
push button (
5
) or (
6
) until the diode goes out.
6.
Button for switch
ing to mowing head’s left
-hand gears and diode signaling turning the head on.
Left-hand gears are turned on, whenever wire or flexible, thick branches get wound up onto the flail
shaft.
Turning left-hand gears on:
a)
If right-hand turns are engaged, turn them off, release the button and wait for 3 seconds (in
this period the buttons are inactive) and then push button (
6
). In order to turn left-hand gears
off hold button (
6
) or (
5
) again until the diode above the button goes out.
NOTE: Once the head rears are off buttons (5) and (6) become inactive for 3 seconds.
7.
Button for turning arm’s floating function and diode for signaling the floating function. To turn
arm’s floating function press button (
7
). To turn the function off just hold the button (
7
) again.
8.
Diode
for signaling turning the mowing head’s floating function on. Turning the head’s floating
function on/off is performed by means of button (
3
) found on joystick (
9.
Diode signaling if the
first arm’s unloadi
ng function is on. Turning the unloading function on/off is
performed by means of joystick’s button (
4
).
10.
Diode for signaling, if admissible oil temperature is exceeded.
Caution! If oil temperature is exceeded, turn the working head off. If oil temperature does not get
lower within 10 minutes, control would be turned off. Control will be turned on again when oil
temperature gets lower. Diode for signaling low oil level.
11.
Diode for signaling low oil level.
1
2
3
4
5
8
9
10
11
6
7