SaMASZ KW 141, Operator'S Manual

Page: 49 / 72

49
OPERATOR’S MANUAL REAR EXTENSION ARMS KWT, CAMEL, KOLIBER, KW, LAMA
Rotating
direction
Operating direction
6.3. Adjusting flail head mowing height
Mowing height adjustment using the mowing head is possible by changing position of ground-
following shaft ( Fig. 52 ). Therefore undo screws fastening the ground-following shaft and re-tighten
them on the desired level.
Additionally, in mowing heads KW it is possible to move the ground-following shaft
backwards by loosening screws I, II or III and 1 ( Fig. 52 ), and then re-tightening them
in holes IV, V or VI and 2 ( Fig. 52 ).
Fig. 52. Ground-following shaft position adjustment
Tab. 8. Possible mowing heights
Setting
Flail head mowing height A [mm]
KW
110 / 125 / 140
KW
111 / 126 / 141
LAMA
120 / 140
LAMA
101(P) /
121(HD) / 141
I + 1 31 26 45 32
II + 1 47 52 65 53
III + 1 64 76 85 73
IV + 1 76 – – –
IV + 2 – 27 – –
V + 2 – 52 – –
VI + 2 36 73 – –
6.4. Replacing knives in mowing adapter
WARNING!
Before any work always check condition of flail knives and their mounts. Do not
use damaged or worn elements due to the risk of throwing objects. Damaged or
worn elements are dangerous.
If necessary a blade should be replaced as shown in Fig. 53 . All blades must be of the same type
and have the same weight. Blades should be purchased from the manufacturer of the machine -
"SaMASZ".
If rotor of cutterbar is equipped with standard knives, make sure whether these are mounted in
right direction.
Fig. 53. Knife mounting manner