Operator’s manual
Double-sided disc mowers
with central suspension
- 28 -
Fig. 19a. Steering box
Fig. 19b. Placement of steering box and cable attachment socket RS
(1) on KDD mowers, I – mowers
without belt conveyors, II – mowers with belt conveyors
5.2.1.
Setting mower in transport position on headlands
In order to set the mower in transport position on headlands, push button (1)
on Fig. 18.
To use one of the cutterbars such as the right one, lift both of them to transport position on
headlands and prevent the left one against falling with button (13)
. The right cutterbar is
protected against falling with button (14)
.
Protection of the chosen cutterbar is signalled with a red diode located over the button which
corresponds to the cutterbar. In order to unlock a particular cutterbar, push either buttons (13)
or
(14)
again – unlocking cutterbar protection is then signalled by dimming of the red diode.
5.2.2.
Setting mower in vertical transport position
In order to set mower in vertical transport position (Fig. 23), push button (5)
. If near the end of
lifting phase and the cutterbars are stopped and mechanical protection devices are not locked, then
increase pressure in unloading system. To do this, push button (5)
again (disabling is then
signalled by dimming of the green diode), push button (4)
and continue setting the mower in
transport position until mechanical protection is locked. Next, disable control by pushing button (1)
.
I
II
1
1
RS cable attachment to steering panel
ON/OFF switch for steering panel
power
