Operator’s manual
Double-sided disc mowers
with central suspension
- 13 -
No person (except operator) should stand within danger area which is a minimum of 164' 1"
from any operating part, especially when operating near roads and in areas with stones and other
debris.
Be certain that children and animals are at a safe distance away from the machine
.
IMPORTANT: Maintenance and adjustment should ONLY be done after the following has
occurred:
tractor’s engine has been stopped
and ignition key has been taken out,
all rotating parts have come to complete standstill (NOTE: cutting knives will
rotate for several minutes after engine is turned off),
the cutterbar is on the ground
, and
Never tamper with or remove safety devices on the machine or make them inoperable.
Before starting work and periodically thereafter, replace any damaged, missing and/or worn
knives and knife holders.
When driving on public roads always comply with local traffic regulations, especially those
concerning warning lights.
When the mower is lifted for repair on 3-point linkage, it should be secured against falling by
mechanical support or by chain.
The bolts and other fasteners have to be periodically checked and, if necessary, tightened or
replaced. DO NOT work with damaged or worn fasteners.
Never lift the mower on tractor linkage when the drive is operating and the cutting discs are
rotating.
When operating the mower, the tractor should always be equipped with operator protection that
is required by laws and regulations.
Never start the mower when the mower blades are off the ground.
Before you start the tractor make sure that all drives are turned off and the levers that turn the
hydraulics are in neutral position.
Never leave tractor’s engine running without supervision. Before you leave the tractor, turn off
the engine and remove the key from tractor’s ignition.
DO NOT operate the mower when driving the tractor backwards.
Permissible inclination of the mower on a slope when working and during transport is 8°.
Exceeding this incline can result in mower tipover.
Never stand between tractor and mower unless tractor and mower are secured against moving
by the tractor’s brake.
If any maintenance must be done under an elevated mower, it must be blocked or otherwise
secured against falling.
When the parts of the mower need replacement, use only original spare parts as described in the
spare parts list. Pay particular attention to PTO shaft’s guards and mower’s and tractor’s spline
shaft guards.
Hydraulic hoses are potentially very dangerous. Do the following to minimize any hazards:
Hydraulic hoses should be periodically checked and if any damage to the hoses have
occurred or if they have been used more than 5 years, replace with new ones.
Never use scotch tape to repair hydraulic hoses.
When connecting hydraulic hoses to tractor’s hydraulic connectors, make sure that
the tractor’s or mower’s hydraulic system is not under pressure.
The mower should be stored under a roof and in a way as to not be hazardous bot people or
animals.
In the event of an accident involving this mower in a field or on a road, follow all applicable
first aid procedures and contact SaMASZ technical service.
Mower should be kept clean, so as to avoid danger of fire.
