Operator’s manual
Double-sided disc mowers
with central suspension
- 46 -
1. In order to clean roller switch lever D, rotate belt to 1 and hold until bulges disappear (Fig. 41).
This should also be performed from the other side of conveyor if necessary.
Fig. 41. Cleaning of conveyor rollers
2. Impurities inside belt can be removed once conveyor is in vertical position. Belt is deflected by
hand and then impurities can be removed with a hook wire.
Fig. 42. Removal of impurities inside the conveyor
6.8.2.
Conveyor belt replacement and adjustment instruction
Mower KDD 860/940 with conveyors must be suspended onto tractor. Lean the mower with
use of upper connector (cylinder) as far as you can to the front – in order to increase the distance
between conveyor and the ground.
I.
The adjustment of the belt conveyor should be done only when the conveyor is in its
working position (horizontal).
1.
Using a marker, mark lines on millimetre measures – decal 77 (if belts worked well).
2.
Loosen tightening roller mechanism – screws M10 - S
1
, nuts M12 – N
2,
and loosen
adjustment screw M12 – S
2
by approx. 1.2" (Fig. 43).
1
Bulges
1
D
