23
ZetrOZ, Inc.
Product Support
203-349-2798
13. Modes of Operation
13.1. ON (UNLOCKED) MODE
To turn the device ‘ON’, fi rst ensure the Lock Switch is in the unlocked position as
indicated by the unlocked symbol on the
sam
Power Controller Module. Press and
hold the
Power Button
for at least 1 second. Press the
Toggle Button
on the right side
of the
sam
Power Controller Module to set the treatment duration. The treatment
duration may be set for 1, 2, 3 or 4 hours. The battery indicator LED and treatment timer
LED will be displayed on the control panel (see section 8: LED Display). The applicator
indicator LED will be displayed on each attached applicator (See Figure 2, page 10).
Each connected applicator will emit ultrasound energy immediately upon the
sam
Power Controller Module entering the ‘ON’ mode of operation. The
sam
Applicator will
emit ultrasonic energy whether the device is locked or unlocked (locking is optional). A
powered
sam
Applicator will always emit ultrasonic energy unless it enters the
sam
Sensing Mode or the treatment duration concludes.
13.2. ON (LOCKED) MODE
Once the device is powered ‘ON’, the user may lock the control panel settings by
sliding the
Lock Switch
on the
sam
Power Controller Module to the ‘locked position’ as
indicated by the lock symbol on the
sam
Power Controller Module. This will prevent the
device from unintentional shutoff during treatment. While locked, the
Power Button
and
the
Toggle Button
cannot be modifi ed. The
sam
Applicator will emit ultrasound whether
the device is locked or unlocked. To change the treatment duration or turn the power
off , simply slide the
Lock Switch
to the ‘unlocked position’ as indicated by the symbols
on the
sam
Power Controller Module then press the desired user button.
Warning: If the Lock Switch is in the locked position, the Power Button will not turn off
the device until the Lock Switch is placed into the unlocked position. Locking
the treatment settings is not required.
13.3. OFF MODE
When the device is ‘OFF’, the LEDs on the applicator will not be illuminated, the LEDs
on the
sam
Power Controller Module will not be illuminated, and no ultrasound energy
will emanate from the device. Always turn the device ‘OFF’ when not in use or if pain or
uncomfortable heating is indicated by the patient.
