English
Installation and operating instructions Salmson SNF-S
57
See fig. 23: Bearing bracket
• Remove the circlips and cover.
See fig. 24:
• Completely remove the shaft.
• Remove the roller bearing.
9.6
Installation
General
Check O-rings for damage and replace them, if necessary. Flat gas-
kets are to be replaced as a matter of principle.
The components are to be cleaned and checked for wear before
installation. Damaged or worn parts must be replaced with original
spare parts.
Location points are to be coated with graphite or something similar
before installation.
DANGER! Risk of fatal injury!
Risk of fatal injury and risk of injuries to personnel and property
damage due to improper handling.
• The safety instructions and regulations included in section 2
“Safety” on page 3, and in section 9.1 “Safety” on page 21, are to
be taken into consideration for all maintenance and repair work.
Shaft/bearing bracket
See fig. 25:
• Heat the roller bearings and push onto the shaft
alternatively, press the roller bearings onto the shaft by using a
suitable pressing tool.
See fig. 26:
• Push the shaft into the bearing bracket.
Fig. 23: Bearing bracket
Fig. 24: Shaft and roller bearing
Fig. 25: Bearing assembly
Fig. 26: Shaft assembly
