15
SALICRU
•
Once the reception is finished, it is advisable to pack the UPS
and the battery module/s again till its commissioning in order
to protect it against mechanical shocks, dust, dirt, etc...
4.2.2. Storage.
•
Storage of the equipment will be done in a dry place, safe-
guard from rain, protected from dust, water jets or chemical
agents. It is advisable to keep the equipment and the battery
pack/s, into their original packages, which have been de-
signed to assure the maximum protection during the trans-
port and storage.
•
In general and less in special cases, the UPS has
sealed lead-calcium batteries and should not be
stored for more than 12 months (see the date of the last
charge of the batteries, noted on the label adhered to the
device packaging or on the battery unit).
•
After this period of time, connect the equipment to mains and
together with battery module/s, if any, start it up according to
the instructions described in this manual and charge them for
2 hours from floating level.
•
Finally, shutdown the equipment, disconnect it and fit the UPS
and batteries in their original packaging, noting the new bat-
tery charge date on each respective label.
•
Do not store the devices where the ambient temperature ex-
ceeds above 50ºC or below -15ºC, otherwise it may degrade
the electrical characteristics of the batteries.
4.2.3. Unpacking.
•
The packaging of the equipment consists of a cardboard
enclosure, expanded polystyrene corner pieces (EPS) or
polyethylene foam (EPE), polyethylene sleeve and band,
all of them are recyclable materials; therefore they should
be disposed according to current regulations. We recom-
mend to keep the packaging in case its use is necessary
in the future.
•
Proceed as follows:
Cut the strips of cardboard enclosure.
Remove the accessories (cables, supports, ... )
Remove the equipment or battery module from the pack-
aging, keeping in mind that the it is needed the help of a
second person depending on the weight of the model.
Remove the protection corners from the packaging and
the plastic bag.
Do not leave the plastic bag at the children hand,
due to the risk that it means.
Check the equipment before proceeding and in case
damages where confirmed, contact with the supplier or
in lack of it with our firm.
4.2.4. Vertical assembling -tower type- or
rack.
•
All the UPSs from
SPS.ADVANCE RT
series are designed
to assemble the equipment as tower format -vertical position
of the equipment- or rack -horizontal position- for its installa-
tion in 19" cabinets.
Follow the instructions stated in the sections related to any
of both possibilities, attending the particular configuration of
your equipment.
•
Figures from 4 to 9 show as an example the graphics of an
equipment. These illustrations are only for help and orien-
tation in the steps to follow and they are not particular for
any model, although in practice, the actions to make are the
same for all models.
Nevertheless when the generic illustrations differ, there will
be new illustrations to show it.
•
All the instructions relating to connections will detailed later
on, less those ones regarding the battery connection. There-
fore, this section will only describe the works linked with the
assembling.
4.2.4.1. Removing or fitting the beauty cover.
"C"
"D"
"D"
Fig. 4.
Taking out the beautiful front cover.
