Sakai SW300-1, Shop Manual

Page: 137 / 246

6-033
VIBRATORY DRUM
·
REAR WHEEL
② A gap will remain between end of boss SUBASSY and
inside of cover (24).
• Tighten bolts (23) to a torque of 7.8 N·m (6 lbf·ft).
• Give disc SUBASSY two to three turns.
• Tighten bolts (23) to a torque of 7.8 N·m (6 lbf·ft) again.
• Repeat this work several times until tightening torque of
bolts no longer fl uctuates.
(NOTICE)
• Tighten bolts alternately in diagonal directions.
(NOTICE)
• It is necessary to rotate the bearing to lift the rollers
while pressing in the inner race. Otherwise the
bearing will not seat no matter how forcibly the inner
race is pressed.
③ Remove bolts (23).
• Remove cover (24).
• Remove shim.
(NOTICE)
• Do not turn the disc SUBASSY after the cover is
removed.
SW300-1-06072
23 24
Gap
Disc
SUBASSY
Boss
SUBASSY
SW800-06080
End of rollers in close
contact with inner race shoulder
Gap
Gap
(1) Bearing not
seated
(2) Bearing correctly
seated
SW300-1-06073
23
24
Shim
06̲VIBRATORY̲DRUM.indb 6-033 06̲VIBRATORY̲DRUM.indb 6-033 2012/11/20 8:26:06 2012/11/20 8:26:06