Sakai SW300-1, Shop Manual

Page: 50 / 246

3-006
ENGINE AND CONTROLS
3-1-1. Installation of pump
• When the pump has been removed from the engine for
repair or replacement, reinstall it in accordance with the
following procedure.
① Apply adequate amount of lithium-based grease to pump
(5) and coupling (4) splines.
② Secure coupling (4) to engine fl ywheel with six bolts (3)
and spring washers.
N•m
(3) Bolt M 8×20 : 17 N·m (13 lbf·ft)
③
Secure housing (1) to pump (5) with two bolts (6), spring
washers and washers.
(NOTICE)
• When secure housing (1), it is cautious of attachment
position.
N•m
(6) Bolt M14×40 : 167 N·m (123 lbf·ft)
④
Spline of pump subassembly is united with spline of
coupling and then secure pump subassembly to fl ywheel
housing with seven bolts (2), spring washers and washers.
(NOTICE)
• When secure pump subassembly, it is cautious of
attachment position.
N•m
(2) Bolt M10×40 P=1.25 : 49 N·m (36 lbf·ft)
(NOTICE)
• Bolts (3) are treated with thread-locking
fl uid. Use new
thread-locking fl uid treated bolts for installation.
SW300-1-03001
1
2
6
5 3
4
03̲ENGINE̲AND̲CONTROLS.indb 3-006 03̲ENGINE̲AND̲CONTROLS.indb 3-006 2012/11/14 17:13:36 2012/11/14 17:13:36