Sakai SW300-1, Shop Manual

Page: 148 / 246

6-044
VIBRATORY DRUM
·
REAR WHEEL
4-2-2. Installation of rear axle
1) Install rear axle in reverse order in which it was removed.
• Tightening torque for bolts where particular care is
required when installing rear axle.
(12) Bolt M14x50 : 167 N·m (123 lbf·ft)
(22) Bolt M20x80 : 265 N·m (195 lbf·ft)
2) Upon installing rear axle, pay particular attention to items
mentioned below.
• Fill hydraulic oil tank to speci fi ed level to make up for any
oil leakage.
• Start engine and circulate oil through piping. Then check
oil level again, ensuring that oil is at speci fi ed level.
(NOTICE)
• If the engine is run at high speed or the cylinder is
operated to full stroke when the engine is started
for the
fi rst time after the work is completed, the
piston packing or other items may be damaged by air
entering into the cylinder.
N•m
06̲VIBRATORY̲DRUM.indb 6-044 06̲VIBRATORY̲DRUM.indb 6-044 2012/11/20 8:26:07 2012/11/20 8:26:07