2. OPERATION
2.4 Vibratory Operation
1) Run the engine at 1,800 rpm or higher by operating the
throttle lever.
2) Switching from 1 to 4 causes vibration at higher
amplitude.
Vibration 1 operates even in stop state if the engine
speed is 1,800rpm or higher, but vibration 2 to 4
operates only while moving forward or backward.
When the forward-reverse lever is placed in the neutral position during rolling compaction
work at vibration 2 to 4, return is made to the amplitude of vibration 1. Tilting the lever
again resets the amplitude to the selected one of 2 to 4.
_
IMPORTANT ________________________________________________________
•
Avoid long-time vibration at vibration 1 while the machine stops.
•
If traveling becomes impossible due to mud, etc. during vibration rolling
compaction, immediately stop vibration.
•
Because of the characteristic of the amplitude selector system, switching to
lower amplitude such as from 4 to 3 or from 3 to 2 cannot be sensed, and in order
to switch to lower amplitude, therefore, turn the amplitude selector switch to
"OFF" once, and then select the amplitude again.
2.5 Sprinkler
1) Before sprinkling, check for the water level in the sprinkler tank with the 'sight gauge.
Add water as necessary.
2
1
_______
3
OFF<
—4
IMPORTANT
Use clean water wherever practicable.
2) Sprinkler switch controls sprinkling. Sprinkler switch
selects sprinkler modes; continuous sprinkling mode
and intermittent sprinkling mode.
ON .......... Continuous sprinkling
INT .......... Intermittent sprinkling
Sprinkling duration can be adjusted within 0 - 20
seconds with dial ®. Idleing duration can be set within
0 - 60 seconds by turnng dial 0. Adjust the dials to
meet job conditions. (Sprinkler Dial ®, Idle Dial 0)
Sprinkler switch
10
0
2 0 0 0 6 0
(SEC)
Sprinkler
Idle
Sprinkler Dial ® Idle Dial ®
Sprinkle
ON
—36—
