2. OPERATION
Adjusting spread of nozzle
When the liquid is sprayed to the tire, the spread of the
nozzle should be adjusted so that the liquid will be applied
within the tire width.
The spread of the nozzle is adjusted with the round handle
of the valve
0
located at the liquid valve end of the
front/rear tires.
Counterclockwise turning of round handle ....
Clockwise turning of round handle .............
To increase the spread of the nozzle
(spraying rate is increased)
To decrease the spread of the
nozzle (spraying rate is decreased)
5) In case when such liquid as cutting oil that may be
frozen when it is cold, open the valve
0
at the left
end of the machine front/rear as well as the valve
above the liquid tank after the work is completed, and
press the liquid spray switch to drive the pump, and
then drain the liquid completely. In addition, the same
procedure should be done for long-term storage. Close
both cocks when using it again.
A
CAUTION _______________________________________________________
•
Light oil, kerosene, etc. must not be sprayed to tires because they will cause tire
swelling/deformation and asphalt discoloring.
•
Pump driving when the liquid tank is empty is allowed only for a short time. If
the pump is driven for a long time when empty, failure may be caused.' Attention
should be paid to the liquid level.
-
40 -
