SAINT-GOBAIN Norton Clipper CM 401 Series, Operating Instructions Manual

Page: 21 / 30

VERS. 2017.06.12 CM 401_MAN_EN
21
5.2.4 General advice for the cutting

Material weighting under 30 kg and having dimensions smaller than 500x500x220mm for the CM
401500 and 600x500x220mm for the CM 401600 can be cut with the machine.

Before commencing work make sure tools are firmly seated!

Before using the machine, make sure the two anti-tipping devices are tighten correctly. Loosen
the knob (1 on picture 5), and tighten the anti-tipping device (2) so the sheave (3) leans firmly on
the profile (4).
Picture 5: tightening of the anti-tipping device

Select the right tools as recommended by the manufacturer depending on the material to be
worked, the working procedure (dry or wet cut) to be carried out and the required efficiency.

Apply cooling water continuously whilst cutting and in good time! Make sure the water pan
contains enough water.

When dry cutting, ensure sufficient dust extraction and wear a dusk protection mask!

When cutting work is finished, close the water-tap so you can remove the cut pieces from the
conveyor cart without getting wet.

If the thermal protection trips, reactivate the motor by pushing on the black button located on the
motor (230V motors) or on the switch (115V motors), or allow the thermal protection to cool down
(400V motors). Wait a few minutes to allow the motor to cool down before restarting the machine.