SAINT-GOBAIN Norton Clipper CM 401 Series, Operating Instructions Manual

Page: 16 / 30

VERS. 2017.06.12 CM 401_MAN_EN
16
its maximum rotational speed, then turn the Star-Triangle-switch on

.
The direction of rotation is indicated on the blade guard. If the direction of rotation does not correspond
to the direction shown by the arrow, then reverse the motor polarity by turning the phase inverter
inside the male plug with a screwdriver.
3.4 Water cooling system
Fill the water pan with clean water to approximately 2cm from top (ensure that bottom of pump is fully
immersed in water).
Open water-tap at blade guard (note that handle on water-tap should be in line with water-flow).
Ensure that water is flowing freely in the circuit and is delivered adequately to both sides of the blade,
as insufficient water supply may result in premature failure of the diamond blade.
The water pump must never run without water. Always make sure that there is enough water in the
pan and refill if necessary.
In case of frost, empty the water cooling system from its water.