VERS. 2017.06.01.
CG 252_MAN_EN
12
3
ASSEMBLY AND COMMISSIONING
The machine is delivered assembled, fully equipped and ready for use. Before using the
machine for the first time, follow these simple instructions.
3.1
Tool assembly
Only use tools NORTON. The machine can be used with tools of types: discs, wings.
Turn off the power of the machine and unplug there of the electrical network prior to install or
change a tool. The maximum diameter of tools supported by the machine is 250mm.
To mount a tool, lay the machine so for it rests on its sleeve. (Handle to the ground).
Make sure that the machine will not tip, then mount and tighten your tool.
3.2
Establishment of connections
Check that :
The button "start" (Black) to start is not activated.
The supply voltage and the current type correspond to those of the machine.
Grounding is regulatory.
The power cable is at least 2.5 mm2 of section by phase.
3.3
Establishment of the dust extractors.
During a dry use always use the machine with a dust extractors. A nozzle of connecting at
the level of the frame is provided for this purpose. You simply connect the dust extractors on
this nozzle.
3.4
Establishment of the water supply
A nozzle of connection is provided for a use at the water. You simply connect your arrival of
water on this nozzle. A valve is located downstream of this nozzle to regulate the flow.
3.5 Starting the machine
Turn the guide arm in a comfortable position. To do this, loosen the screw on the
articulation of the arm, turn the arm to the desired angle, and tighten the screw.
Then, adjust the wheel spacing of the rear track according to your needs.
For a dry use, always use a dust extractors.
Connect the pipe of the dust extractors to the machine nozzle provided for this purpose,
then start the dust extractors before starting the machine.
For use with water, open the valve located on the machine to regulate your flow.
You can also connect a dust extractors for a used at the water. To do this connect the
pipe to the dust extractors to the machine nozzle provided for this purpose, and then start
the dust extractors before starting the machine.
Stay behind the machine and then lift the machine off the ground and assuring you that
the polishing or surfacing tool isn't in contact with the ground. Make sure that the protective
casing remains in contact with the ground.
To start the machine, press the button "start" (black).
Start the job by lowering the machine until the tool work effectively on the ground.
To stop the machine, press the button "Stop" (red).
Unplug the machine from the electrical network and wait for the complete shutdown of
the work tool.
