SAGEMCOM MF 9841, Installation Manual

Page: 20 / 90

MF 9841 MF 9626/9631/9841 1 – 17
5) Press [EXECUTE] key.
The printer color patch image (adjustment pattern) is printed
out. (A3 or 11" x 17" paper is automatically selected.
6) Set the color patch image (adjustment pattern) printed in the
procedure 5) on the document table.
Place the color patch image so that the fine lines are on the left
side. At that time, place 5 sheets of white paper on the printed
color patch image (adjustment pattern).
7) Press [FACTORY] key on the operation panel, and press
[EXECUTE] key.
The printer color balance adjustment (step 1) is automatically
performed and the color balance check patch image is printed
out.
If there is any streak or unclear print on the printed check pat-
tern, check the print engine for any problems.
8) The initial setting menu of the half tone image correction is dis-
played. Press [OK] key.
The initial setting of the half tone image correction is per-
formed.
9) When "COMPLETE THIS PROCEDURE" is displayed, the
adjustment operation is completed. Cancel the simulation 46-
74 by pressing the [CA] Key.
NOTE: The adjustment result becomes valid only when the both
adjustments in the copy mode and in the printer mode are
completed.
For example, if the copy color balance adjustment (auto-
matic adjustment) is performed and the simulation is can-
celed, the adjustment result is invalid.
ǂǂǂ6,08/$7,21ǂǂ12
&/26( 7(67
(1*,1($872$'-8670(176(59,&(
&21),507+($'-3$7&+$1'35(66>(;(&87(@72$'-2)5(*,675$7,21(;(
$1'35,177+(7(673$7&+
3/($6(86(63(&,),('7<3(2)$25h6,=(3$3(5
)257+,6$'-8670(17
(;(&87(
PRINTER CALIBRATION
ǂǂǂ6,08/$7,21ǂǂ12
&/26(
7(67
(1*,1($872$'-8670(176(59,&(
2.
3/($6(:$,7
12:5(*,67(5,1*7+(1(:7$5*(72)+$/)721(352&2167
;
/
%
$M
2
3
/CZ
1 0 / . - , + * ) ( ' & % $ #
High density Low density
ǂǂǂ6,08/$7,21ǂǂ12
&/26( 7(67
(1*,1($872$'-8670(176(59,&(
&21),507+($'-867('3$7&+$1'35(66>2.@725(*,67(57+,63$7&+'$7$
2.
ǂǂǂ6,08/$7,21ǂǂ12
&/26( 7(67
(1*,1($872$'-8670(176(59,&(
&203/(7('7+,6352&('85(
3/($6(48,77+,602'(