45
46
9.
Check Belt Tightness
Hold child restraint at the belt
path with your weakest hand.
Push and pull from side to side.
It should not move more than 2.5
cm (1 in.).
To Release UAS
Remove child from child restraint.
Remove UAS from vehicle anchors
by pressing the red release button on
each connector.
Store UAS when not in use.
See page 26.
If it moves more than 2.5 cm (1 in.),
you can try:
A.
Pulling the belt tighter.
B.
Reinstalling the child restraint.
C.
Changing to a different seating location.
D.
Switching to vehicle belt installation.
Vehicle Belt Installation
WARNINGS:
Do not use the UAS
along with the vehicle lap or lap/
shoulder belt. Secure UAS connectors
as shown when using the vehicle belts.
Check the vehicle belt before each use.
Use only if the belt is tightened properly
and securely.
Do not use any recline position except to install the child
restraint fl ush against the vehicle seat back. Vehicle seat
back must be upright.
Failure to follow these warnings can result in serious
injury or death.
1.
Place Child Restraint
Forward Facing
Flush Against
Vehicle Seat Back
Do not use any recline positions
except to make the child restraint
flush against the vehicle seat back.
Vehicle seat back must be upright.
Safety Tips
Make sure harness and buckle fit your child correctly before
installing the child restraint. See pages 3-4.
Experts agree that children should remain rear facing as long as
possible. In this child restraint, your child can remain rear facing up
to 18 kg (40 lb) and up to 91 cm (36 in.).
continued on next page
4358-6870 CAN Alpha Select ENG.indd C45-C46
4358-6870 CAN Alpha Select ENG.indd C45-C46
2/10/16 12:18 PM
2/10/16 12:18 PM
