© Safe Fleet | May 2018 | All rights reserved | Part #: 700-1111 R2
inView 360 Fusion Calibration Guide
p. 4
Introduction
Introduction
This guide covers the calibration procedure for the
inView 360 Fusion Around Vehicle Monitoring (AVM)
system. This
guide does not go into the installation procedure for any of the AVM components (cameras, electronic control unit, in-
vehicle monitor, wires and cables). Before taking on the calibration process, all components should already be installed in
the vehicle.
For more information on how to install the components, please see the inView 360 Fusion Installation Guide on the Seon
Community (https://community.seon.com/360-fusion/360-fusion-resources/). For access to the community website,
please contact the Seon Service Team to get a username and password (email [email protected], or call toll-free
1.844.899.7366)
About the AVM
The inView 360 Fusion Around Vehicle Monitoring (AVM) system provides drivers with a real-time, 360° picture of the area
around their vehicle to help eliminate blind spots, improve pedestrian safety, prevent vehicle damage, and avoid liability
costs.
To achieve the 360° picture, 4 images are captured from cameras positioned in the
front
,
left
,
right
, and
rear
of the
vehicle. These images are then transferred to a computer and calibrated using software. Once calibrated, the images are
transferred back to the vehicle and viewed on a monitor mounted in the cab of the vehicle.
