Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au
Page 8 of 12
12
Measure and mark two hole
positions on the air cleaner
base inlet approximately
10mm in from the end of the
air cleaner base inlet and
23mm (long side) and 15mm
(short side) down from the
radius of the inlet as shown.
Drill the two marked hole
positions using a 5.0mm drill
bit.
13
Install the air cleaner inlet
adaptor (item 10) into the air
cleaner base inlet, drill the
two 5.0mm holes through
the air cleaner base and into
the air cleaner inlet adaptor.
Remove the adaptor and
deburr the holes.
