Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au
Page 5 of 12
6
Install the upper mounting
bracket (Item 3) to the
snorkel body (Item 1) with
hex bolts (Item 4).
Apply Loctite 243 to each of
the stainless steel mounting
studs (Item 7) and install the
studs finger tight into the
snorkel body (Item 1)
mounting inserts as shown.
7
Place a strip of masking tape
along the A-pillar panel.
Carefully install the snorkel
body (Item 1) to the guard
panel.
With the snorkel body
correctly positioned on the
vehicle, accurately mark the
position of the upper
mounting bracket (Item 3)
onto the masking tape.
Note: open/close the front
door and check the
clearance between the
door rubber and hex bolts
(item 4). If necessary raise
the position of the snorkel
body on the A-pillar to
achieve adequate
clearance.
