INTEGRA-X User Manual
WEB GUI
SAF Tehnika JSC
60
46)
CRC Align. Errors
– The total number of packets received that had a length (excluding
framing bits but including FCS octets) of between 64 and 1518 octets, inclusive, but had
either a bad Frame Check Sequence (FCS) with an integral number of octets (FCS Error) or
a bad FCS with a non-integral number of octets (Alignment Error);
47)
Jabbers
– The total number of packets received that were longer than 1518 octets
(excluding framing bits but including FCS octets), and had either a bad Frame Check
Sequence (FCS) with an integral number of octets (FCS Error) or a bad FCS with a non-
integral number of octets (Alignment Error).
Note that this definition of jabber is different than the definition in IEEE-802.3 section 8.2.1.5
(10BASE5) and section 10.3.1.4 (10BASE2). These documents define jabber as the
condition where any packet exceeds 20 ms. The allowed range to detect jabber is between
20 ms and 150 ms;
48)
Ingress BPS
– Indicates byte per second rate on the input of the port;
49)
Ingress PPS
– Indicates packet per second rate on the input of the port;
50)
Egress BPS
– Indicates byte per second rate on the exit of the port;
51)
Egress PPS
– Indicates packet per second rate on the exit of the port;
52)
All CoSQ out Pkts.
- total packet count with QoS transmitted
53)
All CoSQ out bytes
- total byte count with QoS transmitted
54)
All CoSQ dropped Pkts.
– total packet count with QoS dropped
55)
All CoSQ dropped bytes
- total byte count with QoS dropped
56)
Clear all statistic
– Clears statistics on all switch ports;
57)
Clear
– Clears statistics on a particular port.
CLI commands
See Chapter 4: COMMAND LINE INTERFACE
network port show statistics
Use to show Ethernet statistics on all ports.
network port reset statistics
{LAN1|LAN2|LAN3|MNG|WAN|all}
Use to reset Ethernet statistics for a particular port or
all ports.
