INTEGRA-X User Manual
WEB GUI
SAF Tehnika JSC
42
Modify mode
1)
Egress rate / Status
– Indicates whether the egress rate is enabled or disabled on a
particular port (status mode); allows enabling/disabling egress rate on a particular port
(modify mode).
2)
Egress rate / CIR
– Indicates the configured egress rate CIR (Committed Information Rate)
on a particular port in Mbps (status mode); allows setting egress rate CIR on a particular
port in Mbps (modify mode). The default setting is “1000”.
3)
Egress rate / CBS
– Indicates the configured egress rate CBS (Committed Burst Size) on a
particular port in kB (status mode); allows setting egress rate CBS on a particular port in kB
(modify mode). The default setting is “2000”.
4)
Ingress rate / Status
– Indicates whether the ingress rate is enabled or disabled on a
particular port (status mode); allows enabling/disabling ingress rate on a particular port
(modify mode).
5)
Ingress rate / CIR
– Indicates configured ingress rate CIR (Committed Information Rate) on
a particular port in Mbps (status mode); allows setting ingress rate CIR on a particular port
in Mbps (modify mode). The default setting is “1000”.
6)
Ingress rate / CBS
– Indicates configured ingress rate CBS (Committed Burst Size) on a
particular port in kB (status mode); allows setting ingress rate CBS on a particular port in kB
(modify mode). The default setting is “2000”.
7)
By pressing
„Execute configuration”,
changes made to the corresponding section apply only
to the local side Integra-X. If
„Rollback on”
is selected, the configuration will be reverted in
case erroneous configuration changes are applied.
CLI commands
See Chapter 4: COMMAND LINE INTERFACE
network port show egress-rate
<port>
Use to show egress rate limit settings and status of a
particular port.
network port show ingress-rate
<port>
Use to show ingress rate limit settings and status of a
particular port.
network port set LAN1 egress-
rate cir <96…1000000kbps> cbs
<64…2056kB>
Use to set Committed Information Rate (CIR) and
Committed Burst Size (CBS) setting for egress rate limit
on LAN1 port.
network port set <LAN2|LAN3>
egress-rate cir
<96…10000000kbps> cbs
<64…2056kB>
Use to set Committed Information Rate (CIR) and
Committed Burst Size (CBS) setting for egress rate limit
on LAN2 or LAN3 port.
network port set LAN1 ingress-
rate cir <96…1000000> cbs
<64…2056>
Use to set Committed Information Rate (CIR) and
Committed Burst Size (CBS) setting for ingress rate limit
on LAN1 port.
Figure 3-27 Modify mode
