INTEGRA-X User Manual
COMMAND LINE INTERFACE
SAF Tehnika JSC
96
:
COMMAND LINE INTERFACE
Command line interface (CLI) is available via 4 individual interfaces:
Secure Shell (SSH);
Telnet (disabled by default);
Serial terminal;
Web GUI
, partial functionality)
The available CLI commands are found in “CLI commands” tables in corresponding Web GUI page
sections in
For SSH, Telnet or serial connection you can use any client supporting corresponding interfaces
(e.g. PuTTY, Tera Term, etc.).
CLI commands are not case sensitive.
A User can abbreviate commands and parameters as long as they contain enough
letters to be distinguished from any other currently available commands or
parameters.
Useful CLI keyboard shortcuts can be printed by CLI command help.
Figure 4-1 CLI keyboard shortcuts
Note that in Web GUI console (described in subsection
those
shortcuts will not work.
Connecting to serial RS232 interface
In order to connect to an Integra-X serial terminal, you will require a USB cable with a USB Type B
connector. See chapter
for pinouts.
To connect the PC to the RS-232 serial management port, using serial terminal-emulation
software (e.g. PuTTY), use the following parameters:
Baud rate: 115200
Data bits: 8
Parity: None
Stop bits: 1
Data flow control: None
Below are connection steps with PuTTY - Windows freeware software.
1)
Open PuTTY and go to “Serial” category. Specify your COM port number you will be using,
change “Speed (baud)” to “115200” and “Flow control” to “None”, see
