1. Turn on the control box by pressing the power button over the 3 seconds.
2. Press the APEX/ENDO button to set to ENDO mode .
3. Select the program number by pressing the program button.
4. Save the program by pressing the memory button over the 2 seconds after setting the auto reverse mode,
gear ratio, speed(RPM), torque. Ring the beep sound if the program is saving.
(Function of each buttons refers to ‘BUTTONS ON THE OPERATION PANEL’.)
12
If torque value exceeds the setting value, the handpiece rotates in reverse automatically.
When a load is removed, the handpiece stops.
Operation within the
setting torque value
- When the batteries go down, the actual load may not reach the preset torque limit value.
In this case (in the case of operation by batteries), this auto reverse function will not be activated.
When high torque is required, use the adaptor or use this product in a condition where the batteries
are not significantly consumed.
- If a load is continuously applied to the motor, it may automatically stop to prevent overheating.
In this case, leave the motor for a while until it cools down. When the display returns to normal,
the product can be used.
- Auto reverse function is not supported in the reciprocating mode (Program No. 8, 9).
Reverse rotation when exceeds
setting torque value
Stop when a load is removed
Operation within the
setting torque value
Reverse rotation when exceeds
setting torque value
Forward rotation when a
load is removed
If torque value exceeds the setting value, the handpiece rotates in reverse automatically.
When a load is removed, the handpiece rotates in forward.
If torque value exceeds the setting value, the handpiece stops.
(EMPTY)
STOP!
- Press and hold the each setting button about gear ratio, speed and torque, value is set rapidly.
- Rotary direction is not saved in program. (Program is set to forward direction.)
- Press and hold the memory button until beep sound when save the program.
Otherwise, program cannot be saved.
<Auto Reverse Function>
- The function is operated when the torque value exceeds the setting value. It can be choose three modes below.
OPERATION PROCESS (ENDO MODE)
