9
- To remove the motor, hold the plug ring and pull it out.
- Please use the designated adaptor only. Please check the battery bar on the LCD display of the main
controller for charging status.
- It takes about 5 hours to complete full recharge, however, it might vary upon surrounding temperature
and battery condition.
Older Batteries might remarkably shorten both charging and operating time.
Under unstable surroundings, such as high temperature or low temperature, the batteries might not be
properly recharged.
Avoid sunlight and use the product at consistent temperature location.
: Please insert the pins of motor cord to the holes position of control box carefully.
1. Motor Connection
2. Probe Cord Connection
: Connect the file clip and lip hook to the probe cord respectively.
Connect the Micro USB terminal of the probe cord to the probe connector
of the main controller.
(When connecting, please check the direction of the Micro USB port.)
In APEX+ENDO mode, connect the connecting cord to the file clip holder
of angle handpiece and the probe cord.
3. Adaptor connection
Please insert the adaptor plug into the adaptor connector exactly.
(When charging the battery)
4. Foot Controller Connection
: Please insert the foot controller plug into the foot controller connector exactly.
