English
- Assemble the cup heating plate (ref.
4,
fig. 11 by inserting
the electrical connector info the electronic board properly,
the fitting into the drain tube (ref.
B,
fig. 11, and by
connecting the earth cable.
- Manually rotate the studs (ref.
A,
fig. 11) so as to place
the milling horizontally.
- Assemble one of the side panels (or ref. 1, fig. 11 or ref.
5,
fig. 11).
Important
Firstly slide in the bottom pins in their frame slots,
then press directly on the studs until hearing the
locking springs snap
.
-
Position the g ass (ref.
2,
fig. 1 1) in the slot of the lateral
panel already assembled.
-
Assemble the other side panel.
-
Insert the drip tray into place (ref. 15, fig. 11).
-
Switch machine on.
6.17 Setting out of operation
Danger
Operation falling within the competence of the
Maintenance technician.
When the machine Is put out of operation, disconnect both
water and electrical mains; empty al trays, boilers and pipes
and clean the whole machine properly (see "7.2 Machine
cleaning").
In case of scrapping, the various materials used in
manufacturing will have to be separated and individually
disposed of, according to each Country regulations in force.
18
Danger
Before any servicing and/or cleaning, disconnect the
machine by way of main switch (ref. 10, fig. 1) and
multi-pole switch (or disconnect the plug) and await
machine cooling.
- The components that cannot be dismantled and the
machine itself, have to be cleaned, unless differently
specified, with cold or lukewarm water only, using non-
abrasive sponges and damp cloths.
- Do not use direct water sprays.
- All parts to be cleaned are easily accessible and do not
require the use of tools.
- Regular maintenance and cleaning will preserve the
machine and maintain its efficiency for a longer period
as well as conforming to health and hygiene norms.
- The machine automatically signals when the
maintenance and/ or descaling interventions are due;
the exact number of dispensing instances is visible by
the mechanical counter or on the machine display. No
intervention of the Maintenance technician may result in
machine locking.
Danger
In case of operation troubles, normally signaled on
display, immediately switch the machine off,
disconnect the power through a multi-pole switch or
by disconnecting the plug and contact the nearest
SERVICE CENTRE.
7.2 Cleaning of machine
Danger
Never clean the machine when it is in "STANDBY" status.
Cleaning must be carried out daily and before any long dead
time, in order to avoid the formation of deposits in containers,
trays and dispensers.
All removable machine components that have to be cleaned
can be washed and rinsed in running water.
Clean machine covers, panels and commands with soft and
dry cloths, or slightly dampened by cold or lukewarm water.
Important
Never wash machine components in the dishwasher.
7 - MAINTENANCE
7.1
Foreword
