Saeco CRISTALLO 600, Use And Maintenance

Page: 48 / 64

48
English
9 OPERATION AND USE
9.1 Beverage selection
The Cristallo 600 vending machine can dispense 50
beverages.
The
Cristallo 400
vending machine can dispense 38
beverages.
The following are the conditions necessary to select a
beverage:
- the vending machine has reached the set temperature
after the start-up. Otherwise, once a beverage key is
pressed, the display shows the message “HEATING”;
- the credit available is sufficient or the vending machine
has been set in free mode. If this is not the case, the
display shows the message “INSERT XXX”;
- there is no error condition that prevents the dispensing
of beverages. If this is not the case, the display shows
the error message “OS BEVERAGES XXX” alternated
with “NOT AVAILABLE”;
- the beverage selected is enabled. If this is not the case,
the message “NOT AVAILABLE” will be displayed;
- there is no block condition for the beverage selected. If
this is not the case, the message “BEVERAGE XXX”
alternated with “NOT AVAILABLE” is displayed before
the key is pressed. After the key is pressed, the display
shows the message “NOT AVAILABLE”;
- the dispensing outlet door is closed. If this is not the
case, the display shows the message “CLOSE SERVICE
DOOR”.
Important
The brewing cycle cannot be interrupted by the dispensing
outlet door open, until cup, sugar and stirrer loading is
complete.
If the door is opened accidentally, it should be closed and
the beverage brewing will continue automatically.
During the brewing of a beverage:
-
payment systems are disabled;
- the first line on the display shows the programmable
dispensing message (default message is: “WAIT FOR
PRODUCT”).
Beverage selection
If the vending machine is not set to dispense free beverages,
insert the credit required.
Press the key corresponding to the beverage required.
When the beverage is dispensed, the message “REMOVE
CUP” is displayed. Take the beverage out of the dispensing
outlet.
After closing the door the display will show the message
“THANK YOU” and after a few seconds “CRISTALLO 400”
(the vending machine is awaiting selection).
Warning
To avoid scalding, wait for the end of brewing signal (the
message “REMOVE CUP” will appear on the display) before
placing your hand in the dispensing outlet.
Do not open the dispensing outlet door while the vending
machine is brewing.
In case of failures or product missing during the brewing
phase, a message indicating the cause of this stop will appear
on the display.
Messages and special warnings are listed in section 11.