Sabo 38-EV, Operator'S Manual, Page: 58 / 86

14
GB
Servicing the wheels
Oil the bearings of the wheels once a year.
– To do this, remove the wheel caps, unscrew the wheel axles and remove the wheels.
– After oiling the bearings, push on the wheels and tighten the wheel axle again so that the wheels still turn easily but
without any play.
16 TROUBLESHOOTING
Fault Possible cause Remedy
from
Motor does not start up within 5
seconds of the device being
switched on
No mains voltage. Connect the mains plug C2 .
Check the fuse.
Connection cable damaged. Have it checked by an authorized
workshop.
Cutter blade shaft blocked Have scarifying depth checked.
Clean the cutter blade shaft (remove the
mains plug first!)
Tilt the machine during start-up.
Have it checked by an authorized
workshop.
Motor stops
Grass is too high Mow the lawn first.
Blockage by foreign bodies Have machine checked by an authorized
specialist workshop.
Working depth to deep Re-adjust the working depth V2 .
Unsatisfactory result
Grass is too high Mow the lawn first.
Blades are worn Adjust the working depth V2 .
Have the blade shaft replaced by an
authorized specialist workshop
Working depth not suitable for grass
and ground conditions
Re-adjust the working depth V2 .
Extreme vibration
Have it checked by an authorized dealer
Blade shaft will not turn
Ribbed V-belt defective Have it checked and replaced if necessary
by an authorized specialist workshop.
Repairs to electrical machines must always be performed only by qualified electricians. Please do not repair them yourself.
In the case of faults and defects which have not been listed here, please contact the nearest authorized dealer. This applies
in particular to appliances with electrical motors, as when these are repaired they must always undergo an insulation
protection test.
Your authorized dealer will also help you if you do not wish to perform any of the maintenance work described here yourself.