Center Hub
(H0130-S)
Main Blade Grip
(H0086-S)
Bearing
10x 19x5mm
(HC422-S)
HC232-S
Socket Head Cap Screw M3x10mm
(HC056-S)
Plastic Ball Link
(H0066-S)
Plastic Ball Link
(H0066-S)
Uniball
M3x4 5H3
(H0065-S)
Left Thread
Right Thread
Note
: Smaller ID
Blade Grip Arm
(H0131-S)
Uniball Radius
Arm Assembly
Linkage Rod Assembly
Damper Derlin
(H0144-S)
Damper Derlin
(H0144-S)
H0346-S
Spindle
(H0097-S)
Uniball Radius Arm... x2
Assembly
Main Blade Grip Assembly...x2
Note
: Larger ID
Washer
10x 16x1mm
(HC230-S)
Oring
(HA024)
Washer 6x 14 x1.5mm
(HC194-S)
Washer 10x 16x1mm
(HC230-S)
Thrust Bearing 10x 18x5.5mm
(HC438-S)
Socket Head Cap
Screw M2.5x18mm
(HC032-S)
Socket Head Cap
Screw M3x16mm
(HC068-S)
Washer
3x4x0.5mm
(HC176-S)
Swashplate Assemly
Center Hub Assembly
Radius Arm
(H0132-S)
Uniball Radius Arm
H0205 (H0132-S)
Flanged Bearing
3x 7x3mm
(HC402-S)
Flanged Bearing
2.5x 6x2.5mm
(HC400-S)
Spacer Arm
2.5x 4x6.3mm
H0253 (H0132-S)
Spacer Arm 3x5x2.7mm
H0134 (H0132-S)
Main Blade Grip
Assembly
Bearing 10x 19x5mm
(HC422-S)
Approx. 75mm
Radius Arm ... x2
Assembly
Uniball
M3x4 5H3
(H0065-S)
Uniball
M3x4 5H18
(H0063-S)
Swashplate
Assemly
(H0023-S)
Uniball
M3x4 5H3
(H0065-S)
Linkage Rod A Assembly ...x2
Radius Arm
Assembly
The HPS head should be assembled with one, 1mm shim
(HC230) and one, 0.2mm shim (HC232) on each side. If the
blade grips are too tight, you can remove the 0.2mm shim
(HC232) from each side. After approximately 10/20 flights,
please check preload, you can add one or two 0.2mm shim
(HC232) if preload has changed.
(Initial length for the rods from the swash plate
to the Blade Grip.)
Button Head Cap Screw
M6x10mm
(HC122-S)
Oring
(HA024)
Note:
The main rotor is assembled provisionally
without loctile. Need to add Loctile 243 in the
screws M4x10 and M6x10
Copyright@2013 - SAB Heli Division - All rights reserved
Page 15
Chapter 6, Head
