DE-BURR THE SIDE FRAMES
We recommend de-burring the edges of the carbon parts in areas where electrical wires run.
ESC INSTALLATION
The speed controller (ESC) is installed in the front of the helicopter.
Figure 1 shows the mounting area. Figure 2 shows the installation of the Jive 120 HV ESC from Kontronik.
You can also use the heat sink (H0165-S) if you wish for improved cooling.
Figure 3:
Passage
recommended for ESC
wires. Consider the
movement of the
battery tray.
Figure 4:
Show the
installation of the ESC
with heatsink. Note
that carbon plate
(H0088) has been
removed.
Figure 5:
The passage
of the controller wires
to the motor is
highlighted.
Figure 6:
Show the
installation of a 2S
battery for flight
control system.
Alternatively, a BEC
could be placed in the
same area.
ESC Cables
2S Battery or BEC
Copyright@2013 - SAB Heli Division - All rights reserved
Page 19
Chapter 9, Installation Of The ESC
