RYTEC Pharma-Roll, Installation Manual

Page: 10 / 24

6
INSTALLATION—SIDE COLUMN MOTOR SUPPORT
4. Once the side column is properly positioned, secure
it to the wall using the appropriate anchors. (See
“ANCHORING METHODS” on page 3.) Anchor
holes have been provided in the side column. (See
Figure 12.) DO NOT tighten the anchor hardware at
this time.
NOTE: Use
¹₂
-in. diameter expansion shell stud-
type anchors for concrete walls or
¹₂
-in.
diameter threaded through bolts for brick
walls and other applications where expan-
sion bolts are not acceptable.
Use a tape measure to ensure that proper
width alignment is maintained between the
side columns, at the top and bottom ends
of each column. DO NOT tighten the
anchors at this time.
5. Mount the other side column to the wall in the same
manner as outlined above for the first side column.
SIDE COLUMN MOTOR SUPPORT
On doors greater than 14 feet tall (or wide),
a side column motor support will be sup-
plied with the small parts box as seen in
Figure 13. Failure to install this part prop-
erly may result in equipment failure and/or
personal injury.
Figure 13
IMPORTANT: For doors that are oversized
beyond 14 ft. in height (or width)
should have a side column
motor support included in the
small parts box.
SPREADER ASSEMBLY
Door without Hood Assembly
1. Attach an L-shaped support bracket to each end of
the spreader extrusion using two
³₈
-16 x 1
¹₄
-in.
serrated-flange hex screws and nuts. The brackets
and mounting hardware were shipped in the small
parts carton. (See Figure 14.)
Figure 14
2. Attach the spreader assembly to the inside face of
each side column using two
³₈
-16 x 1
¹₄
-in. serrated-
flange hex screws and nuts at each end of the
assembly. Face the spreader so the brush is toward
the front of the door. (See Figure 15.)
A7600056
A8500004
Serrated-Flange
Hex Screw (Two
L-Shaped Support
Bracket (Mounted to
Top of Header
Spreader
Extrusion
Serrated-Flange Hex
Nut (Two on Each End)
on Each End)
Extrusion)