
3
English
|
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
■
Keep proper footing and balance. Do not
overreach. Overreaching can result in loss
of balance.
■
Always be sure of your footing on slopes.
Walk, never run.
■
Do not allow hands or any other part of
the body or clothing inside the feeding
chamber, discharge chute, or near any
moving part.
■
Never use the product with defective guards
or shields, or without safety devices, such
as debris collector, in place.
■
Keep the power source clear of debris and
other accumulations to prevent damage to
the power source or possible fire.
■
Do not modify the product in any way or
use parts and accessories that are not
recommended by the manufacturer.
WARNING
If the product is dropped, suffers heavy
impact, or begins to vibrate abnormally,
immediately stop the product and inspect for
damage or identify the cause of the vibration.
Any damage should be properly repaired or
replaced by an authorised service centre.
■
To reduce the risk of injury associated with
contacting moving parts, always turn off
the product and disconnect from the power
supply. Make sure that all moving parts
have come to a complete stop:
●
before clearing blockages or unclogging
the chute
●
before leaving the product unattended
●
before checking, cleaning, or working on
the product
●
before inspecting the product after
striking a foreign object
●
whenever the product starts to vibrate
abnormally (inspect immediately)
■
Immediately turn off the product and
disconnect from the power supply in the event
of accident or breakdown. Do not operate the
product again until it has been fully checked
by an authorised service centre.
BLOWER SAFETY WARNINGS
■
Wear a face filter mask in dusty conditions
to reduce the risk of injury associated with
the inhalation of dust.
■
Do not point the blower nozzle in the
direction of people or pets.
■
Never place objects inside the blower
tubes.
■
Do not use the product near open windows.
■
Slightly dampen surfaces in dusty
conditions.
■
Use the full blower nozzle extension so that
the air stream can work close to the ground
and perform effectively.
■
In blower mode, use the product with
the vacuum tubes fitted, or remove them
and close the fan guard. You must never
separate the vacuum tubes and operate
with only the upper tube fitted. These
tubes are designed to be a one-time fit. If
you attempt to separate the fitted vacuum
tubes, the tubes will be damaged. This
significantly increases the potential for
serious injury by contact with the rotating
fan.
■
Do not place the product on top of or near
loose debris. Debris can be sucked into the
intake vent, resulting in possible damage
to the product.
VACUUM SAFETY WARNINGS
WARNING
Never operate the vacuum with only the
upper vacuum tube
fi
tted. Failure to follow
this warning increases the risk of personal
injury.
NOTE:
Without the lower vacuum tube
fi
tted,
it is much easier to reach up inside the tube
towards the fan blade.
■
Do not operate the vacuum without the
debris collector bag assembly installed.
Flying debris could cause serious injury.
Make sure that the debris collector bag is
in good condition and completely closed
before operating the product.
■
Move the vacuum from side to side along
the outer edge of the debris. To avoid
clogging, do not place the vacuum tube
directly into the debris pile.
■
Hold the motor higher than the inlet end of
the vacuum tube.
■
To avoid serious injury to the operator
or damage to the product, do not try to
Summary of Contents for RBV2800CSV
