6 – English
NOTE: MAINTENANCE INSTRUCTIONS BEGIN ON PAGE 7 FOLLOWING
FRENCH AND SPANISH LANGUAGE SECTIONS.
ILLUSTRATIONS START ON PAGE 8.
OPERATION
ADJUSTABLE HEAD
See Figure 4, page 9.
CAUTION:
Do not place hands or fingers between adjustable head
and frame when positioning work light to avoid pinching
your fingers or hands.
To adjust the direction of the light, twist the adjustment
knob counterclockwise. Rotate the light head to the desired
position and turn the adjustment knob clockwise to tighten.
MOUNTING THE LED WORK LIGHT
See Figures 5 - 7, page 9.
WARNING:
Only hang or mount LED work light in an area where no
electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang work
light from any electrical power cord. Ensure work light is
securely installed to prevent falling object hazard. Failure
to follow these instructions can result in electrocution,
electrical shock, or other serious personal injury.
The light can be mounted to fit the application and work
environment. It may be used as a freestanding unit by placing
the light on its base on a flat surface.
NOTE:
Be careful not to mount or hang the light in such a
way that it prevents normal operation or damages the cord.
2x4 recess:
Secure wood into 2x material recess to mount light. Make
sure the wood is seated completely inside the 2x4 recess.
Cord retainer:
The cord retainers can be used to hang the light from a sturdy
location such as a fence.
Tripod mount:
The light may be mounted onto a tripod using the 1/4-20
insert in the base of the light. Screw the tripod into the hole
on the base of the light.
WARNING:
To reduce the risk of a tipping hazard, always ensure the
tripod is stable before and after mounting the light. Do
not use the tripod if it is not stable.
INSTALLING/REMOVING POWER CORD
See Figure 2, page 8.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
Remove the battery pack.
Route the power cord through the cord retainer.
Insert the female end of the power cord into the product
as shown.
Connect the male end of the power cord to the power
source.
Make sure the power cord is secured before beginning
operation.
WARNING:
Keep light away from combustible materials. If wrapped
or in contact with fabrics, the work light lens can produce
sufficient heat to melt some fabrics. To avoid serious
personal injury, never allow the work light lens to come
in contact with anything.
POWER BUTTON
See Figure 3, page 8.
The light will be in the OFF position until the power button
is pressed.
Connect the product to an AC or DC power supply.
Press and release the button once to activate HIGH mode.
Press and release the button again for MEDIUM mode.
Press and release the button again for LOW mode.
Press and release the button a fourth time to turn the light
OFF.
NOTE:
Press and hold the button in any mode to turn the
light off.
NOTE:
This light is equipped with a low voltage indicator. If
the light flashes 3 times while a battery pack is installed, this
indicates a low charge condition. Three additional flashes
indicate that shutdown will follow quickly. Install a charged
battery pack and resume operation.
