![background image](http://html1.mh-extra.com/html/ryobi/p2107vn/p2107vn_operators-manual_1503920012.webp)
10 — English
STARTING/STOPPING THE BLOWER (AC)
See Figures 4 - 6.
Remove battery pack from the blower if installed.
Slide power selection door over battery port until it clicks
into place.
Route an extension cord loop through the slot located
above power cord receptacle and wrap through the cord
retainer.
NOTICE:
Always use cord retainer to properly attach extension
cord to the blower. Failure to use cord retainer may result
in damage to the blower and/or extension cord.
Attach the outlet end of an extension cord to the plug on
the rear of the the blower.
NOTE:
Use only approved outdoor extension cords.
To start the blower, place the power switch in the
ON ( l )
position.
To stop the blower, place the power switch in the
OFF
( O )
position.
OPERATING THE BLOWER
See Figure 7.
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas such
as gutters, screens, patios, grills, porches, and gardens.
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
After using blowers or other equipment, CLEAN UP!
Dispose of debris properly.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF position when not in
use or carrying at your side.
OPERATION