RynoWorx RA-MLT-0005, Operator'S Manual

Page: 19 / 31

12. Valve Control Arm Installation and Adjustment
Type 1:
Install the valve control arm through the guide hole (handle end first).
Ensure that the retainer washer is in place to prevent the spring from
pulling through the guide hole.
Adjust the length of the control arm by threading the
lower half of the arm into the upper half. The final
length of the arm should result in the valve being
fully open (fully open valve position below) when the
arm is fully retracted (shown above/left).
⚠
WARNING
Setting the control arm to a length that is too short will
cause over-rotation of the valve which could lead to
the valve jamming or falling out.
The valve should NEVER be rotated more than a few
degrees past the vertical position. The maximum
valve rotation is shown on the right.
Make sure to test and verify that your setup is free
from jams and over-rotations before using your
machine.