Installation, operating and maintenance manual SKIT/S-DEB
3rd print version
page 24
3 – Design and function
RWO GmbH
●
Marine Water Technology
●
Bremen
●
Germany
Issue 2014-04-10
·
On/Off switch el. heater 2S1
If the oily water separator is equipped with an
electric heater, this button switches it on or off
(
à
Fig. 10 Control box).
LED
3.15.2
The display contains 4 LEDs which permanently indicate
special operating states. Some of the 4 LEDs are multi-
coloured.
White LED (power)
This LED indicates readiness for operation. This LED
illuminates as soon as the voltage supply of the control is
activated and the control is ready for operation.
Red LED (failure)
This LED indicates a failure state. The cause of the failure
can be found on the display.
Red/orange/green LED (status)
This LED indicates the operational state of the oil
separator. Green indicates oil separation in progress. Red
indicates oil discharge in progress. Orange indicates
flushing in progress.
Green LED (bilge level)
The green LED indicates that the level in the bilge tank is
high and that the oil separator can start operation.
(
à
10.4 Meaning of the message lights)
Keys
3.15.3
The control panel has 4 buttons. With these buttons you
can enter all input and query the operating states.
·
ESC button
This button is enabled in all operating states. It
serves to undo the previous operating stage. In the
menu structure, pressing the ESC button exits one
menu level and returns to the previous menu level.
All settings remain. After pressing the button
repeatedly, you reach the start level, the operating
status display.
·
button, +button
With these buttons you can modify settings. They
are only active in the menus in which settings can
be defined. They can be identified by words or
numbers highlighted by flashing. If words are
highlighted, select the left word with the –button.
Accordingly select the right word with the +button in
these menus. If numbers are highlighted, you can
set them by the digit with the -/+ buttons. To jump
from one digit to the other, use the Enter button
(see below).
