24
RUSH Strobe CWL
TM
User Manual
3. Clean glass by wiping gently with a soft, clean lint-free cloth moistened
with a weak detergent solution. Do not rub the surface hard: lift particles
off with a soft repeated press. Dry with a soft, clean, lint-free cloth or low-
pressure compressed air. Remove stuck particles with an unscented
tissue or cotton swab moistened with glass cleaner or distilled water.
4. Check that the fixture is dry before reapplying power.
Replacing the primary fuse
If the fixture is completely dead, the fixture’s primary fuse may have blown
and it may be necessary to install a new fuse. See ‘Fixture overview’ on page
14 for the fuse location.
To replace the primary fuse:
1. Disconnect the fixture from power and allow it to cool.
2. Use a large flat-bladed screwdriver to unscrew the cap of the fuse holder.
3. Remove the blown fuse. Replace with a new one of the specified type and
rating only.
4. Reinstall the fuse holder cap before reapplying power.
If the replacement fuse blows immediately, disconnect the fixture from power
and refer it to a qualified service technician. Do not attempt to use the fixture
until it is repaired.
Other service and repairs
There are no user-serviceable parts inside the fixture. Do not open the
housing.
Refer any service or repair operation not described in this manual to an
authorized RUSH by Martin™ service technician. Do not try to carry out such
an operation yourself, as doing so may present a health or safety risk. It may
also cause damage or malfunction, and it may void your product warranty.
Installation, on-site service and maintenance can be provided worldwide by
the Martin™ Global Service organization and its approved agents, giving
owners access to Martin’s expertise and product knowledge in a partnership
that will ensure the highest level of performance throughout the product’s
lifetime. Please contact your RUSH by Martin™ supplier for details.
