RUSH Strobe CWL
TM
User Manual
21
5) Set the master fixture’s trigger mode. See ‘Selecting trigger mode’ on
page 20. If using music trigger (SOUND MODE = ON), adjust the sound
trigger level as well.
6) Set the master fixture’s DMX STATE setting to SHOW MODE. (See
‘Behavior when DMX signal is not present
’
on page 18).
Set all other connected fixtures to be slaves. If you want all slaves to flash at
the same time as the master, use the SLAVE1 option. If you want to achieve
dynamic effects with multiple fixtures using a trigger delay, skip SLAVE1 on
the first 3 slaves and set them to SLAVE2, SLAVE3, and SLAVE4. If you have
more than 4 fixtures, start over using SLAVE1 instead of MASTER.
To set up slave fixtures:
1) On each slave fixture, press MENU to enter the control menu.
2) Select MASTER/SLAVE. Press ENTER.
3) Press UP or DOWN to select a slave mode (SLAVE1 – SLAVE4).
4) Press ENTER to save the setting.
5) Set the DMX STATE setting to SHOW MODE. (See ‘Behavior when DMX
signal is not present
’
on page 18).
Make sure that the fixtures are not receiving a DMX control signal. When
fixtures are correctly connected and set up for master/slave operation, the
Master status LED on the master fixture and the Slave status LED on slave
fixtures light constantly.
If master/slave synchronization is lost, press MENU on the master fixture's
control panel. Then, after a few seconds, press MENU again to exit the
menus. This will restore synchronization.
Utilities and readouts
Backlight on/off
To turn the control panel display backlight on or off:
1. Press MENU to enter the control menu.
2. Select BACK LIGHT and press ENTER to confirm.
3. Select ON or OFF.
4. Press ENTER to save your selection. Press MENU to exit.
Auto test
To perform a test of all fixture functions:
1. Press MENU to enter the control menu.
