KT332N Cutting &engraving control system user manual V1.1
57
the life of the laser. The system selects the general mode by default.
Aperture size
：
When the general mode is selected for the scanning mode, this
parameter is invalid. When the special mode is selected, this parameter becomes
effective. The controller controls the parameter between 50% and 99%.
Prompt
The cutting and scanning process parameters cannot exceed the limit
parameter values in the axis parameters. If the axis parameters are
exceeded, the setting is illegal, and the system will automatically cover
the process parameters with the axis parameters.
（
3
）
Feeding parameters
Delay before feeding
：
The time can be set from 0 to 300s. After the previous work is
completed and the value is delayed, the feeding axis will start to move. It is convenient
for users to feed and pick materials on the feeding device during the delay time.
Delay after feeding
：
The time can be set from 0 to 9.9s, which is convenient to delay
after the feeding device moves in place, and wait for the feeding shaft to completely
stop before performing the second work.
Feed line by line
：
If the progressive feed function is enabled, the virtual array graphics
in the Y direction will be processed at the same position, and the feed axis will move
once each time.
Line-by-line feed compensation
：
Due to the inaccuracy of the feeding shaft
movement, the feeding length can be compensated by setting this item.
（
4
）
Reset parameters
Reset speed
：
Speed of X / Y-axis linkage return to origin
X-axis power-on reset
Y-axis power-on reset
Z -axis power-on reset
U-axis power-on reset
The parameter of the above four parameters are optional, "Yes" and "No", which are used to
configure whether each axis is reset when it is turned on.
（
5
）
Frame parameters
Frame mode
：
"Fire off and go to the border" means idle, to realize the border preview
function. “Fire on to cut the border" can realize the manual cutting of the processed
graphics. "Dots in the four corners" means that on fire at the four corner points of the
frame, and one point is shot, and other place fire off. The size and position of the figure
can be visually viewed through the four points. The speed of frame moving is the speed
value set on the keyboard when the system is idle. If the fire on, the minimum /
maximum power of the fire is the corresponding value set on the keyboard when the
system is idle).
Prompt
If the frame is out of bounds, the interface will prompt out of bounds
information. At this time, if you press the OK key, the system will cut the
frame with the maximum / minimum coordinates, and then perform the
frame moving operation. You can also cancel this operation.