KT332N Cutting &engraving control system user manual V1.1
34
Figure8.6.1-7
When the IP is changed, user should <Write > make the parameter valid.
8.6.1.7Jog settings
When the red selection box is stopped on the item and press [OK] key, the following interface
pops up:
Figure 8.6.2
Refer to Section 8.10 for parameter setting operation. Press the [Esc] key. The interface exit and
returns to the previous interface.
When the jog mode is in "continuous", the jog parameters have no effect. When returning to the
main interface, when the direction key is pressed, the axis moves, and when the direction key is
popped up, the axis stops moving. When the jog mode is "Jog", each time the direction key is
pressed, the corresponding motion axis runs one time and runs .The distance is equal to the jog
distance value set by the user (without exceeding the machine format).