KT332N Cutting &engraving control system user manual V1.1
28
Figure 8.4-2
Press ENT again, the following interface pops up:
Figure 8.4-3
Refer to Section 8.10 for parameter setting operation. After setting, press [ENT] to save the
modified parameters, and press the [Esc] key to exit the interface.
8.5 Layer function
When the systems is completed / idle in the main interface, if there is layer information in the
layer parameter area, as shown below:
Figure 8.5-1
Press [ENT] to enter the parameter area. Use the up and down arrow keys to select the layer
parameter area. At this time, the "red selection box" appears in the first line of the layer list, as
shown in the figure below: