KT332N Cutting &engraving control system user manual V1.1
41
8.6.17 Backup factory parameters
Select the "Backup factory parameters" item in the menu interface, and press the [OK] key to pop
up the password interface. For password input operations, refer to section 8.8. If the password is
entered correctly, the system will back up all current factory parameters and user parameters to
factory parameters, the interface prompts “set parameters successfully".
Prompt
When the machine delivery from the factory, use the "Backup Factory
Parameters" function to back up all debugged factory parameters and
user parameters, and then at any time, you can use "Restore Factory
Parameters" to restore all factory and user parameters .
8.6.18 Restore factory parameters
In the menu interface, select the "Restore Factory Parameters" , and press the [OK] key to pop
up the password input interface. For the password input operation, refer to section 8.8. If the
password is entered correctly, the system will restore all current user parameters and vendor
parameters with the factory parameters that were set before. The interface prompts
"Successfully restored parameters."
8.6.19 Controller management
When the "red selection box" is stopped on the item and press [OK] , the following interface pops
up:
Figure 8.6.13
Press the [OK] key on the corresponding entry to execute the corresponding function, and press
the [Esc] key to return to the previous menu.
<backup to U disk> “press this button, controller will backup the user and vendor parameters to