USB Ports Configuration
Click the
USB Configuration
button to access the primary USB configuration page.
There are two USB Ports available on the gateway.
1)
Enable USB port
: Each port can be enabled or disabled.
2)
Translate Scancodes
: Default state is checked. Most USB barcode readers behave like keyboards
which send multiple codes to indicate the state of Control, Alt, Shift and other non-printing keys.
The majority of users will want to translate these messages into US ASCII.
USB Port LED Behavior
USB LED Status:
Next to each USB port is a LED which signals the status of that USB port.
1)
Off
: No USB device detected.
2)
Slowly Flashing Green (1Hz)
: Unsupported USB device connected.
-
The gateway only supports Class 3 HID (Human Interface Device) and Class 7 Printer
devices.
3)
Solid Green
: Supported USB device connected.
BI-LED Status:
1)
Alternate Quick Flash Green (5Hz)
: If the 2 USB LEDs are alternating flashing green at a 5Hz rate,
then the gateway is in Configuration Mode and the USB devices are not communicating to the
gateway.
2)
Simultaneous Flashing Green (5Hz)
: Fuse blown because of USB wiring problem.
3)
2 Second Green Blink
: Printer Out-of-Paper
4)
Repeating 2 Green Blink for 1 second, then off for 2 seconds
: Printer Error (e.g. paper jammed,
out of ink, etc.)
5)
Alternate 1 sec Green Blink
: Gateway is in configuration mode.
Real Time Automation, Inc.
30
1-800-249-1612
