5
To
Power Pack
DC TRACK
Terminals.
If StationMaster does not turn on.
reverse direction on transformer.
To
TRACK
Place MAGNET
on bottom of engine.
Sensors in PARALLEL.
Reversing using Sensors
PROGRAMMING
:
Set programming blink 1 to use sensors.
(See programming instructions for more info)
Set acceleration and deceleration rates as desired.
Set time delay on ends as desired.
RR-Concepts.com
C
R
R
Reversing Operations using Sensors
When sensors are used the StationMaster will reverse before every acceleration
and ignore the next DECEL sensor it encounters after a reversal. Using sensors provides
a more consistent day-to-day operation regardless of changing speeds changing trains, etc.
This is a more reliable operation for multiple train sidings where the trains travel at different
speeds.
This hookup requires a sensor to be placed on the extreme ends to signal the StationMaster
to begin the deceleration/pause/acceleration sequences.
Terminals
8 & 9 to end
sensors
Terminals
10 & 11 to
in-between sensoers
In-Between Station Stops
For in-between station stops add sensors to terminals 10 & 11 wired in parallel.
Note that 2 sensors must be used for each stop. Place sensors so that the train
stops between these sensors. This will allow the train to stop at the same position
regardless of direction. There is no limit to the number of stops that can be added.
If only one stop is desired in-between then one sensor can be used however the
train will stop at a different location for each direction due to the deceleration distance.
Two sensors are recommended.
1
2
3
4
8
9
10
11
12
13
StationMaster
Optional STOP sensors
on the ends attached to 12
& 13 will allow precise stopping
location and realistic
“creep-stop” when enabled.
