15
Programming:
Factory Reset
To set the StationMaster back to factory defaults perform the following:
1: Enter programming mode by turning the top speed dial fully counter-clockwise
2. Press and hold both button #1 AND button #3 at the same time.
3 Turn the top speed dial fully clockwise to exit programming mode.
Do not power off without first turning the dial fully clockwise.
The factory default settings are:
* Acceleration rate 1 blink.
* Deceleration rate 1 blink.
* Time delay 15 seconds.
* Train count: 2
* Creep settings reset
* Deceleration times reset
* Operating mode (features) set as follows:
Blink 1 = RED, Sensor Reversing Mode: OFF.
Blink 2 = GREEN, Fire YardMaster before accelerating:
Blink 3 = RED, Reverse before every acceleration: OFF
Blink 4 = RED, Fire YardMaster only in forward direction: OFF
Blink 5 = RED, Disable current sensor: OFF
Blink 6 = RED, Enable CREEP-STOP mode: OF
Fully
counter
clockwise
RRConcepts.com
